Dansons Group CC1 User Manual download pdf (Page 18)

Canadian Comfort Industries www.stovesunlimited.com

Dansons Group Inc.

Floor Pad

Floor

Frame

(bolts)

(ground wire)

MOBILE HOME INSTALLATION

CAUTION: DO NOT INSTALL STOVE IN SLEEPING ROOM

THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR,

CEILING/ROOF MUST BE MAINTAINED!

Your VULCAN “V” Series stove has been tested and listed for mobile home installation. It may be installed in a

mobile home as a "Free Standing Stove" or a "Hearth Stove", see detailed install and clearance requirements

in these sections as they imply there.

In addition to all previously detailed installation requirements, mobile home installations

must meet the following requirements:

Permanently bolt your stove to the floor, (A), figure 26.

Electrically ground your stove or the pedestal to the steel frame of the home. Use a number 8 gauge

copper wire, (B), figure 26, or equivalent.

The stove must have a permanent outside air source with a ¼ inch screen over the inlet.

Figure 25, (B, C & D)

For transportation all chimney/vent above the mobile home must be removed.

Chimney/PL Vent must be 3” or 4” PL Vent and must extend a minimum or 36” above the roofline of

the mobile home and must be installed using a UL / ULC listed ceiling fire stop (J), figure 25, and

rain cap (L), figure 25.

INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.

Floor Pad

Combustion Air Intake

Fresh Air Duct

Fresh Air Hood

Stove Exhaust

Pipe Adapter

Clean Out Tee

Tee Support Bracket

Pipe

Firestop Spacer / Ceiling Support

Roof Flashing / Storm Collar

Rain Cap

Figure 25 Figure 26

Note: When moving your Mobile Home, all exterior venting must be removed while Mobile Home is

being relocated. Upon completion of relocation all venting must be reinstalled and securely fastened.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

No comments

Dansons Group CC1 User Manual Page 18