Dansons Group CC1 User Manual download pdf (Page 14)

Canadian Comfort Industries www.stovesunlimited.com

Dansons Group Inc.

6”

1”

10”

6”

1”

10”

12”

HROUGH

ALL

6”

3”

10”

NTERIOR

ERTICAL

FREESTANDING INSTALLATION

HEATER PLACEMENT:

Stove must be placed so that no combustibles are within, or can swing within (i.e. drapes doors),

36” of the heater.

If the stove is placed in a location where the ceiling height is less than 7’, it must follow the

requirements in the section “Alcove Installation”.

FLOOR PROTECTION REQUIREMENTS:

Stove and floor protection must be installed on a level secure floor

The stove must be installed on a non-combustible floor protector (i.e. sheet steel with cement, tile

slate) extending the full width and depth of the stove and extending 6” in front of the stove. Floor

protector needs to be a minimum of 24.5” deep X 30.5” wide and be a minimum of .018” thick (26

gauge).

Must extend under and 2” to each side of chimney tee (if used).

MINIMUM CLEARANCES TO COMBUSTIBLES

(Figures 12-17)

1” From Back Of Heater to Combustibles 3” From PL Vent to Combustibles

10” From Front Side of Heater to Combustibles

1” From Back Corner of Heater to Combustibles 6” Non Combustible Surface In Front Of Heater

16” From Top Of Heater to Combustibles 36” to drapes, doors, anything that can swing

CLEARANCES – “STRAIGHT INSTALLATION”:

Figure 12 Figure 13

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 36 37

No comments

Dansons Group CC1 User Manual Page 14